Differences

This shows you the differences between two versions of the page.

--- en:anti-tailgating_at_doors_with_input_signals [2020/02/26 09:04]
jhlee2
+++ en:anti-tailgating_at_doors_with_input_signals [2021/12/17 10:53] (current)
peterk
@@ Line 1: / Line 1: @@
 ====== Anti-Tailgating At Doors With Input Signals ======
-The anti-tailgating feature is supported from the BioStar 2.7.8 and the latest firmware of Suprema devices. To use this feature, you need to upgrade both BioStar 2 and device firmware over the below versions.
+The anti-tailgating feature is supported from the BioStar 2.7.8 and the latest firmware of Suprema devices. To use this feature, you need to upgrade both BioStar 2 and device firmwares to the versions listed below or above.
 \\
@@ Line 6: / Line 6: @@
 \\
-When you matched both BioStar 2 server and device firmware version, you can configure anti-tailgating feature in 'Door' and 'Device'.
+When you match both BioStar 2 server and device firmware version, you can configure anti-tailgating feature in 'Door' and 'Device'.
 \\
@@ Line 12: / Line 12: @@
 \\
 ====== 1. Anti-tailgating at door ======
-In the door configuration page, you can see the anti-tailgating feature as the below.
+In the door configuration page, you can see the anti-tailgating feature as below.
 \\
-You can configure the anti-tailgating as the exit button or the door sensor.
+You can configure anti-tailgating as an exit button or a door sensor.
 \\
@@ Line 35: / Line 35: @@
   * If you try to re-add the anti-tailgating feature configured device in the lower BioStar 2 version, you need to do factory reset the device.
 </callout>