Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
en:bew2_revision_note_170 [2023/01/27 09:21] mashin |
en:bew2_revision_note_170 [2024/06/12 10:25] (current) mashin |
||
|---|---|---|---|
| Line 7: | Line 7: | ||
| <callout type="primary" icon="true"> | <callout type="primary" icon="true"> | ||
| - | Devices with the SE processor cannot downgrade to a lower version after upgrading the firmware to v1.7.0.\\ | + | Devices with the new SE processor cannot downgrade to a lower version after upgrading the firmware to v1.7.0 or later. \\ |
| - | Devices with existing SE processor can be downgraded to a lower version.\\ | + | Devices with existing SE processor can be downgraded to a lower version. \\ |
| - | For more information, check the serial number of the device and contact the Suprema (supremainc.com). | + | For more information, check the serial number of the device and contact the Suprema. (supremainc.com) |
| </callout> | </callout> | ||
| \\ | \\ | ||
| - | ==== New features and improvements ==== | + | ==== New Features and Improvements ==== |
| <text size="large">1.</text> Supports setting the byte order for smart cards. \\ | <text size="large">1.</text> Supports setting the byte order for smart cards. \\ | ||
| Line 19: | Line 19: | ||
| * Supports setting the byte order of data to be output to Wiegand or OSDP. | * Supports setting the byte order of data to be output to Wiegand or OSDP. | ||
| - | <text size="large">2.</text> Improved Arm/Disarm state to be written directly to the device's memory so that the state persists even if power is lost. \\ | + | <text size="large">2.</text> Improved the Arm/Disarm status is maintained if the device loses power. \\ |
| <text size="large">3.</text> Supports the dual SE processor. \\ | <text size="large">3.</text> Supports the dual SE processor. \\ | ||
| Line 38: | Line 38: | ||
| <text size="large">6.</text> The card ID was always output as MSB through OSDP when the card ID is input while the device was connected by an intelligent slave (Affects version: v1.6.3). \\ | <text size="large">6.</text> The card ID was always output as MSB through OSDP when the card ID is input while the device was connected by an intelligent slave (Affects version: v1.6.3). \\ | ||
| - | <text size="large">7.</text> Device does not recognize some HID iCLASS Seos cards (Affects version: v1.0.0). \\ | + | <text size="large">7.</text> Device does not recognize certain HID iCLASS Seos cards (Affects version: v1.0.0). \\ |