Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
en:how_to_configure_an_interlock_zone [2021/12/29 15:37] peterk |
en:how_to_configure_an_interlock_zone [2024/01/23 02:23] (current) kate |
||
|---|---|---|---|
| Line 15: | Line 15: | ||
| CoreStation should be a RS485 Master of the local zone | CoreStation should be a RS485 Master of the local zone | ||
| - | FW : cs40 v1.1.0 or higher version | + | FW : v1.1.0 or higher version |
| - | The interlock zone will be supported by CoreStation firmware. It means that you can use any devices for Interlock Zone Configuration as slave devices of CoreStation. | + | The interlock zone will be supported by CoreStation firmware. It means that you can use any devices for Interlock Zone Configuration as slave devices of CoreStation. |
| + | |||
| + | Please note that Corestation does not support FaceStation F2 and BioStation 3 as Slave devices. | ||
| </callout> | </callout> | ||