Differences

This shows you the differences between two versions of the page.

--- en:how_to_configure_d2_keypad [2019/02/14 10:27]
yjjung [Adding as a Slave Device]
+++ en:how_to_configure_d2_keypad [2021/12/29 14:45] (current)
peterk
@@ Line 3: / Line 3: @@
 ====== How to Configure D2 Keypad ======
 Xpass D2 Keypad is a new device introduced with BioStar 2.6.2. \\
-It is a dummy reader for reading cards or PIN, which means it doesn’t perform data matching on the device. \\
+It is a dummy reader for reading cards or PIN, which means it doesn’t perform data matching on itself. \\
-The device can be used as slave device, or a Wiegand reader to send Wiegand output. \\
+The device can be used as a slave device, or a Wiegand reader to send Wiegand output. \\
-The device sends out a Wiegand signal with the default 26bit format and the Wiegand configuration will be done with a separate tool. \\
+The device sends out Wiegand signals with the default 26bit format and the Wiegand configuration will be done with a separate tool. \\
+- Link to the information about the tool: [[http://kb.supremainc.com/knowledge/doku.php?id=en:how_to_use_suprema_device_manager_app|How to use Suprema Device Manager App
+]]
+ \\
 ===== Adding as a Slave Device =====
-You will need a master device to add the slave D2 Keyapd device. \\
+You will need a master device to add the slave D2 Keypad device. \\
-Refer to the article below to learn how to search a slave device. \\
+Refer to the article below to learn how to search for slave devices. \\
 [[en:2xfaq_rs485_mode_master_default_slave]]
@@ Line 18: / Line 21: @@
 {{:en:d2Keypad_option1.jpg?nolink&700|}} \\
-<callout type="warning" icon="true">
-**'Input card ID from keypad' is not supported when master CSN is set to LSB. ** \\
-</callout>
 <callout type="info" icon="true">
 **Possible key input ranges ** \\