Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision Next revision Both sides next revision | ||
|
en:how_to_make_doors [2016/07/08 13:36] 127.0.0.1 external edit |
en:how_to_make_doors [2020/06/02 09:35] kate |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| {{tag>"System Configuration" "BioStar 2" Door}} | {{tag>"System Configuration" "BioStar 2" Door}} | ||
| - | ===== How to make doors ===== | + | ===== How To Add and Configure Doors ===== |
| ---- | ---- | ||
| <callout type="tip" icon="true"> | <callout type="tip" icon="true"> | ||
| - | With the door setting, the basic relay and door level alarm configurations are supported. The minimum door element is 'Relay'. | + | With the door setting, basic relay and door level alarm configurations are possible. The minimum door element is 'Relay'. |
| - | As long as you set a relay, it can be configured as a door. This is useful for the case of having to make a door open or close at the time of the designated event, such as fire alarm, or emergency lock down. | + | As long as you set a relay, it can be configured as a door. This is useful for the case of having to make a door open or close at the time of a designated event, such as fire alarm, or emergency lock down. |
| </callout> | </callout> | ||
| Line 25: | Line 25: | ||
| * Exit device refers to the device located inside for exit input. | * Exit device refers to the device located inside for exit input. | ||
| * Therefore, it's necessary to set to use a door relay from a exit device or a door IO device, such as Secure IO 2 and DM-20, to avoid security risk of exposing a relay wiring to the outside. | * Therefore, it's necessary to set to use a door relay from a exit device or a door IO device, such as Secure IO 2 and DM-20, to avoid security risk of exposing a relay wiring to the outside. | ||
| + | * **Door Sensor** can be used to monitor the door status. BioStar 2 System Administrator or users can know the physical door status via the sensor detection whether the door is opened or closed. Moreover, it can be used to generate an alarm for any unexpected door status. | ||
| + | * It is highly recommended to set the door sensor in BioStar 2 Door Configuration and wire the door status sensor to the door. If the **Door opened** log is detected without the occurrence of the **Door unlocked** log, BioStar 2 software or BioStar 2 Products generate a **Forced door opened** log and also can generate an additional **Forced door open alarmed** to notify the user. | ||
| + | |||
| + | </callout> | ||
| + | |||
| + | <callout type="primary" icon="true"> | ||
| + | Once a device is added to a door, the device authentication mode changes to **No Access**. \\ | ||
| + | In order to allow user access, configure **[[en:how_to_make_access_groups|Access Groups]]**. | ||
| </callout> | </callout> | ||