Table of Contents

Version 1.3.0 (V1.3.0_180317)

Release

2018-03-26

New Features and Improvements

1. Output signal setting for Wiegand reader control.

2. Improves that invalid values can not be entered in the authentication mode, AuthTimeout, MsgTimeout, ScanTimeout, and MatchingTimeout.

3. Support fingerprint enrollment on the slave device.

4. Support the intrusion alarm zone, Muster zone and the ethernet zone.

5. Performs the Access on Card (AoC) matching when connected to a master device as a slave device.

6. Improves user transfer speed.

7. Improves log search within device.

8. User Operator cannot change another user’s Operator Level as Administrator.

9. Support Reset without Network Settings.

10. Support Daylight Saving Time setting.

11. Improves Trigger & Action for duress finger.

12. Support Private Authentication on AoC.

13. Improves to handle the encryption key of the important information stored in database differently from server to server.

14. Support One Device Mode(Legacy).

15. Added a message asking whether to delete the fingerprint in the database after completing AoC issuance.

16. Support the secure tamper.

17. Support ISO14443A 10 Byte CSN.

18. Support connecting with BioEntry R2, BioEntry P2, BioLite N2, and XPass D2.


Bug fixes

1. Problem trying to forward commands related to Config during connection after searching RS-485 slave device.

2. Problem where changes were not reflected on the user interface after changing the device to DHCP disabled and IP and gateway settings.

3. Issue where 'Auth Time Out' message is displayed when waiting after pressing random T & A key.

4. Issue where RS-485 disconnect message is displayed when changing home screen of the slave device to user’s logo.

5. Problem not working in 256 bit Wiegand format.

6. Issue that Wiegand output device prints wrong value when authenticating with fingerprint/ID authentication mode.

7. Issue where some alarm ports remain 'On' when rebooting the master device when an alarm occurs in Schedule Lock state.

8. Problems that do not work when set Open/Short with Supervised input of DM-20 in the elevator control.

9. Problem does not work when enroll fingerprint using Advance Enrollment in the slave device.

10. Problem disconnecting when adding a slave device after setting Log Upload to Manual.

11. Issue that Face authentication information is displayed on devices that do not support face authentication.

12. Problem that the mobile card recognizes as 'Unregistered User' when entering the admin menu.

13. Issue when user ID type is set to alphanumeric, even if a user with ID 32 is set as administrator, it is changed to the normal user.

14. Issue if the elevator is configured as a fire alarm zone, relay operation will be turned off when the alarm is released after the fire alarm.

15. 'Unknown' is displayed when trying to enter detail page of CST sub-slave device.

16. Total count error on filter value when searching.

17. Problem with reading mobile smart cards on Galaxy S4.

18. Galaxy S5 NFC is recognized as a CSN card when authenticating with NFC and the authentication fails.

19. Issue where the touch keypad does not work.