Old revisions Add to book Export to PDF Book Creator Add this page to your book Book Creator Remove this page from your book Manage book (0 page(s)) Help Version 1.3.2 (V1.3.2_210408) Release 2021-04-12 Bug Fixes 1.Card data were output with the wrong BitCount while the device was communicating with a 3rd party controller via OSDP. (Affects version: v.1.0.0) 2. The LED indicator lighted up in cyan when setting it to blue while the device was communicating with a 3rd party controller via OSDP. (Affects version: v.1.0.0) 3. Modified to output 4 bits for each key input on the keypad while the device was set as a Wiegand reader. (Affects version: v.1.2.0) 4. The OSDP LED Temporary command did not work properly. (Affects version: v.1.0.0) 5. While the device was communicating with a 3rd party controller via OSDP, the device connected as a slave responded that it supported transparent mode by OSDP_PDCAP even though it did not actually support that mode. (Affects version: v.1.0.0) 6. Improved the function to operate according to Timer Count when setting the Temporary LED while the device was communicating with a 3rd party controller via OSDP. (Affects version: v.1.0.0) 7. A ‘Receive Timeout’ error occurred with a tamper event while the device was communicating with a 3rd party controller via OSDP. (Affects version: v.1.0.0) 8. When changing the device settings by using the Device Manager while the device was communicating with a 3rd party controller via OSDP, the LED indicator lighted up in blue. (Affects version: v.1.0.0) 9. Delay occurred when reading a smart card that contained credentials which the device did not support while the device was set as a Wiegand reader. (Affects version: v.1.0.0) 10. The LED setting did not reflect changes immediately. (Affects version: v.1.0.0)