Differences
This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
en:how_to_configure_custom_input_event_name [2019/01/03 10:41] tim created |
en:how_to_configure_custom_input_event_name [2022/09/20 15:37] sungjun changed wording "detailed" to "Advanced" |
||
---|---|---|---|
Line 1: | Line 1: | ||
====== How to use custom input event name ====== | ====== How to use custom input event name ====== | ||
- | From BioStar 2 2.7.1v, the custom input even name change is supported for easily searching and detecting input events by given names. \\ It is often used for marking break glass events. | + | **From BioStar 2 V2.7.1,** the custom input event name change is supported for easier searching and detecting input events by given names. |
+ | \\ | ||
+ | It is often used for marking break-glass events and receiving alerts and searching the event by the designated event name. | ||
{{:en:break_glass_event.jpg?600|}} | {{:en:break_glass_event.jpg?600|}} | ||
+ | |||
+ | **How to set?** | ||
+ | |||
+ | 1. Go to the Advanced device setting page, and set 'Trigger & Action' | ||
+ | |||
+ | 2. Choose 'Input(Event Name Change)' and enter trigger settings and choose input(event name change) | ||
+ | {{:en:event_name1.jpg?600|}} | ||
+ | |||
+ | \\ | ||
+ | |||
+ | 3. Choose 'None' for action when it does not need to output relay signals. \\ | ||
+ | |||
+ | {{:en:none_action.jpg?600|}} | ||
+ | |||
+ | |||
+ | 4. Check the monitoring tab to see events and alerts with the custom event names. | ||
+ | |||
+ | {{:en:device_event_12f.jpg?400|}} {{:en:12f.jpg?380|}} | ||
+ |