Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
en:configuration_api [2021/06/06 19:57] kateyu [BS2Rs485Config] |
en:configuration_api [2021/06/06 20:11] kateyu [BS2BarcodeConfig] |
||
|---|---|---|---|
| Line 1714: | Line 1714: | ||
| |1 |Outdoor | | |1 |Outdoor | | ||
| |2 |Automatic | | |2 |Automatic | | ||
| - | |3 |[+V2.8] Not used ''(FaceStation F2)'' | | + | |3 |[+V2.8] Not used ''(FaceStation F2 v1.1.0 or higher version)'' | |
| </WRAP> | </WRAP> | ||
| + | [Note]\\ | ||
| + | FaceStation F2: v1.0.0 - v1.0.5 \\ | ||
| + | Ambient Brightness: Normal, High, ''Auto'' \\ | ||
| + | FaceStation F2: v1.1.0 or higher version \\ | ||
| + | Light Brightness: Normal, High, ''Not Used'' \\ | ||
| + | |||
| **3. //enrollThreshold//** \\ | **3. //enrollThreshold//** \\ | ||
| Threshold of face enrollment. It determines how much movement of pose is allowed when enrolling the face. \\ | Threshold of face enrollment. It determines how much movement of pose is allowed when enrolling the face. \\ | ||
| Line 2395: | Line 2401: | ||
| It must be as the value multiplied by 10 of the temperature to be set. The value is available -50 ~ +50 \\ \\ | It must be as the value multiplied by 10 of the temperature to be set. The value is available -50 ~ +50 \\ \\ | ||
| + | ==== BS2BarcodeConfig ==== | ||
| + | <code cpp> | ||
| + | typedef struct { | ||
| + | uint8_t useBarcode; | ||
| + | uint8_t scanTimeout; | ||
| + | uint8_t reserved[14]; | ||
| + | } BS2BarcodeConfig; | ||
| + | </code> | ||
| + | 1. //useBarcode// \\ | ||
| + | This is the flag for Enabling Barcode or disabling Barcode. \\ \\ | ||
| + | 2. //scanTimeout// \\ | ||
| + | This is Timeout(second) setting for scanning Barcode. \\ | ||
| + | Default second is 4 seconds. The time out can be set from 4 to 10 seconds. \\ \\ | ||
| + | 3. //reserved// \\ | ||
| + | Reserved space. \\ | ||