Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
en:bln2_revision_note_150 [2023/06/21 15:18] mwkim [Release] |
en:bln2_revision_note_150 [2024/08/16 11:13] (current) mashin |
||
|---|---|---|---|
| Line 32: | Line 32: | ||
| <text size="large">3.</text> Device does not connect to a 3rd party controller (Software House iSTAR Edge G2) via OSDP (Affects version: v1.4.1). \\ | <text size="large">3.</text> Device does not connect to a 3rd party controller (Software House iSTAR Edge G2) via OSDP (Affects version: v1.4.1). \\ | ||
| <text size="large">4.</text> When changing the intelligent slave settings on the detailed page of the device on BioStar 2, the settings were not applied (Affects version: v1.4.2). \\ | <text size="large">4.</text> When changing the intelligent slave settings on the detailed page of the device on BioStar 2, the settings were not applied (Affects version: v1.4.2). \\ | ||
| - | <text size="large">5.</text> Migration malfunction occurs when the firmware is upgraded from v1.2.0 or earlier to v1.3.0 or later (Affects version: v1.3.0). \\ | + | <text size="large">5.</text> Migration malfunction occurs when the firmware is upgraded from v1.2.0 or earlier to v1.3.0 or higher (Affects version: v1.3.0). \\ |
| * Migration did not complete and the device boots to the main screen, some keys do not work or an abnormal screen is displayed. | * Migration did not complete and the device boots to the main screen, some keys do not work or an abnormal screen is displayed. | ||
| <text size="large">6.</text> When communicating with a 3rd party control panel via OSDP, the device incorrectly responds as 'Inactive' when receiving the Input Status Request command while the input port is grounded (Affects version: v1.4.1). \\ | <text size="large">6.</text> When communicating with a 3rd party control panel via OSDP, the device incorrectly responds as 'Inactive' when receiving the Input Status Request command while the input port is grounded (Affects version: v1.4.1). \\ | ||
| <text size="large">7.</text> When communicating with a 3rd party control panel via OSDP, the device does not respond to the Output Status Report command while the relay reacts to it (Affects version: v1.4.1). \\ | <text size="large">7.</text> When communicating with a 3rd party control panel via OSDP, the device does not respond to the Output Status Report command while the relay reacts to it (Affects version: v1.4.1). \\ | ||
| <text size="large">8.</text> When communicating with a 3rd party control panel via OSDP, the device incorrectly responds as 'Inactive' when receiving the Output Status Request command while the relay status is 'On' (Affects version: v1.4.1). \\ | <text size="large">8.</text> When communicating with a 3rd party control panel via OSDP, the device incorrectly responds as 'Inactive' when receiving the Output Status Request command while the relay status is 'On' (Affects version: v1.4.1). \\ | ||
| - | <text size="large">9.</text> Device does not recognize some HID iCLASS Seos cards (Affects version: v1.0.0). \\ | + | <text size="large">9.</text> Device does not recognize certain HID iCLASS Seos cards (Affects version: v1.0.0). \\ |