2018-06-20
1. In a device with an LCD, the user name is displayed on the LCD when authentication is successful even when connected in slave mode.
2. Changed the default for the input from Supervised Input to Normal.
3. Support for connecting new devices.
1. Problem where logs are duplicated by repeatedly attempting to input Manual Lock, Manual Unlock, Release, etc. to the door disconnected from the device.
2. Issue where event logs and real-time logs are not uploaded normally to BioStar 2.
3. Problem that relay state is not maintained when reconnecting a device connected by RS-485.
4. Issue in which the door relay status operates as On when the device is reconnected after starting and ending the Schedule Unlock with the door relay device disconnected.
5. Problem that the time zone is not initialized even if the factory reset is performed while secure communication and data encryption key are in use.
6. Issue where if the authentication is successful when the device set as door relay is disconnected, the relay will operate according to previous value after reconnection of the device.
7. Issue where the device restarts when authenticating with an unregistered fingerprint.
8. Issue that are not initialized for the tamper, AC Fail, and Supervised input when the factory reset is performed.