Old revisions Add to book Export to PDF Fold/unfold all Table of Contents Version 1.3.1 (V1.3.1_220607) Release New Features and Improvements Bug Fixes Book Creator Add this page to your book Book Creator Remove this page from your book Manage book (0 page(s)) Help Version 1.3.1 (V1.3.1_220607) Release 2022-06-13 Devices with the new BLE chip cannot downgrade to a lower version after upgrading the firmware to v1.3.1 or higher. Devices with existing BLE chips can be downgraded to a lower version. For more information, check the serial number of the device and contact the Suprema (supremainc.com). New Features and Improvements 1. Supports setting the byte order for smart cards. Supports setting the byte order of data to be output to Wiegand or OSDP. 2. Supports a new BLE (Bluetooth Low Energy) chip. The BLE chip parts of the hardware have been changed, and the firmware has been upgraded to be compatible with both the existing and new BLE chips. 3. Improved the Arm/Disarm status is maintained if the device loses power. Bug Fixes 1. The card ID was always output as MSB through OSDP when the card ID is input while the device was connected by an intelligent slave (Affects version: v1.2.3). 2. The user ID was abnormally displayed in the event log if the user authenticated with AoC set as the blacklist card when the User ID Type was set to Alphanumeric (Affects version: v1.0.0). 3. When the device is connected as an intelligent slave and the first card registered to the user is a Wiegand card of a format other than 26-bit, the CSN value is output through OSDP when authenticated with the user's fingerprint (Affects version: v1.2.3). 4. Mobile card authentication suddenly does not work (Affects version: v1.1.0).