2021-06-01
1. Upgraded to the 1.1.1i version of OpenSSL.
2. Intelligent Slave Support
3. Separated event logs of Mobile Access cards and RFID cards.
1. When calling the BS2_ResetConfigExceptNetInfo API from the BioStar 2 Device SDK, a ‘Timeout’ error occurred. (Affects version: v1.0.0)
2. Card data were output with the wrong BitCount while the device was communicating with a 3rd party controller via OSDP. (Affects version: v1.0.0)
3. When using a static IP while DNS server address was configured, a reboot on the device caused communication problems between the server. (Affects version: v1.0.0)
4. While the device was communicating with a 3rd party controller via OSDP, the device connected as a slave responded that it supported transparent mode by OSDP_PDCAP even though it did not actually support that mode. (Affects version: v1.0.0)
5. If 31 slave devices were connected and one of the devices got disconnected, the master device rebooted. (Affects version: v1.0.0)
6. Fingerprint authentication did not work after downgrading from firmware version 1.4.0 to firmware version 1.2.1. (Affects version: v1.4.0)
7. It was not able to communicate with a 3rd-party controller via OSDP with the default key before network initialization. (only for devices released with the firmware version 1.4.0 or later) (Affects version: v1.4.0)
8. It was able to communicate using default keys after changing the key settings when the device was connected to a 3rd-party device via OSDP. (Affects version: v1.3.0)
9. After initializing the slave device’s settings, it was not able to connect it to a 3rd-party controller. (Affects version: v1.0.0)
10. Secure communication was not available by using the default key after downgrading firmware to version 1.3.1 or below which does not support encryption. (Affects version: v1.4.0)