Table of Contents

1.7.0 Version (V1.7.0_181126)

Release

2018-11-29

New Features and Improvements

1. Support to AES encryption type for DESFire card.
2. Support to DESFire/DESFire EV1 Advanced option.

3. Support to the creation of up to 2048 Access Levels and Access Groups.

4. If a user is registered, modified, or deleted, the event log shows whether the editing was done on the server or on the device.

5. If the data transmission fails when communicating with OSDP, it is transmitted again.
6. Improves the data protection.

7. Change the maximum value of the width for the Wiegand Input.

8. Support to the number of users, fingerprints, faces, and cards in Manage Users in Device.
9. Support for Individual Authentication Successful Messages and Working alarm time reports.
10. When using The bypass, The card ID is output as Wiegand even though a user authenticates with the AoC.

Main Fixes

1. Wiegand Out is not output when authenticating with blacklist card.
2. With Bypass enabled, authentication failure message is not displayed when unregistered ID is authenticated.
3. The user cannot issue a new File after the App and File are created when issuing the DESFire card.
4. A code is added to prevent the authentication fails because the cache memory is broken.

Bug Fixes

1. The alarm can be released in the Floors status after a fire alarm occurs when the elevator is configured as a Fire Alarm Zone.

2. The relays operate differently from the previous status if the slave device is reconnected.

3. Modified the firmware of that slave device so that it cannot be upgraded when a device not supported by the master device is connected as a slave.

4. If a user authenticates the fingerprint consecutively to the slave device, the fingerprint sensor will not operate.

5. Change some special characters (\, /, :, *, ?, “, ', `, <, >, |, .) to be unavailable when setting a user name.

6. An administrator cannot set the permissions of other administrators.

7. If a user authenticates the card to XPass D2 connected to as a slave device, the beep sounds twice.

8. 1: N authentication can also be added on the slave device even though the master device is only capable of 1: 1 authentication.

9. The bit of the fingerprint image is broken.
10. If the user uses the BS_GetLogBlob command to get the door ID, the door ID is not output normally.
11. Amharic Unicode characters are not displayed normally.