Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
en:duplication_check_of_fingerprint_face_for_user_registration_process [2021/12/17 10:39] peterk |
en:duplication_check_of_fingerprint_face_for_user_registration_process [2021/12/29 14:58] (current) peterk |
||
---|---|---|---|
Line 4: | Line 4: | ||
You must match BioStar 2 server version and device firmware versions to enable **'Duplicate Check'** feature. | You must match BioStar 2 server version and device firmware versions to enable **'Duplicate Check'** feature. | ||
\\ | \\ | ||
- | {{ :en:v8_1.png?nolink |}} | + | <callout type="primary" icon="true"> |
+ | ** Supporting Devices: ** | ||
+ | * FaceStation 2 v1.3.0 and over | ||
+ | * FaceLite v1.1.0 and over | ||
+ | * BioStation 2 v1.8.0 and over | ||
+ | * BioStation L2 v1.5.0 and over | ||
+ | * BioStation A2 v1.7.0 and over | ||
+ | * BioLite N2 v1.2.0 and over | ||
+ | * FaceStation F2 v1.0.0 and over | ||
+ | * X-Station 2 v1.0.0 and over | ||
+ | </callout> | ||
===== 1. Basic information of 'Duplicate Check' feature ===== | ===== 1. Basic information of 'Duplicate Check' feature ===== | ||
Line 34: | Line 44: | ||
===== 3. Configure from Suprema device ===== | ===== 3. Configure from Suprema device ===== | ||
* You can configure for fingerprint / face duplicate check, enable or disable. | * You can configure for fingerprint / face duplicate check, enable or disable. | ||
- | * It is only supported in LCD on devices. (Supported on : BioStation 2, BioStation L2, BioStation A2, BioLite N2, FaceStation 2, FaceLite. FaceStation F2) | + | * It is only supported in LCD on devices. (Supported on : BioStation 2, BioStation L2, BioStation A2, BioLite N2, FaceStation 2, FaceLite, FaceStation F2) |
* Device menu (ESC key) - Authentication - Fingerprint / Face - Operation - Duplicate Check | * Device menu (ESC key) - Authentication - Fingerprint / Face - Operation - Duplicate Check | ||
* Default setting in device is 'enabled'. (You should manually set 'enabled' after you upgraded the firmware after you upgrading from 'not supported' version to 'supported' version.) | * Default setting in device is 'enabled'. (You should manually set 'enabled' after you upgraded the firmware after you upgrading from 'not supported' version to 'supported' version.) | ||