FIXME 이 문서는 아직 완전히 번역되지 않았습니다. 번역을 완료하는 데 도와주세요.
(번역을 마치면 이 단락을 지우세요)

하나의 출입문에 입실 장치와 퇴실 장치를 설치한 경우 두 장치를 RS-485로 연결해야 합니다. 하지만, 두 장치 사이를 입력/출력으로 연결하면 RS-485 연결을 사용하지 않아도 됩니다.

장치 ID가 60457, 151인 두 장치를 RS-485 연결 없이 다이렉트로 연결하는 방법에 대해 알아봅시다. 60457 장치의 릴레이 출력 단자는 151 장치의 입력 단자에 연결되어야 하며, 151 장치의 릴레이 출력 단자는 퇴실 버튼과 연결되어야 합니다.

사용자가 60457 장치에서 인증하면 60457 장치의 릴레이가 동작하여

When you attach in and out devices to Door, you need to connect those two devices via RS485 setting one of them as a master device. But there is an alternative way to connect the devices, directly connecting the output of one device to the input of the other device.

In this example, we will directly connect the two devices (60457, 151) to one door without using RS485.

The relay output of Device 60457 should be connected to the input of Device 151 and the input of Device 151 should be set as exit button input. Then, when a person gets authenticated on Device 60457, the relay of Device 60457 gets activated and then Device 151 activates its relay as if its exit button is pushed, thus opening the door.


You can set the input of Device 151 as exit button input as shown in the figure below:


The configuration of Door 2 is as follows: