Differences
This shows you the differences between two versions of the page.
en:how_to_configure_duress_authentication_event_from_trigger_action [2018/04/02 21:28] kate created |
en:how_to_configure_duress_authentication_event_from_trigger_action [2021/12/17 10:27] (current) peterk |
||
---|---|---|---|
Line 6: | Line 6: | ||
In BioStar2 v2.6, you can make a trigger and an action for user authentication event. | In BioStar2 v2.6, you can make a trigger and an action for user authentication event. | ||
- | For duress authentication success, you can configure that as follows. | + | For duress authentication success, you can configure the trigger and action as below. |
- | Note: Duress Finger is that a fingerprint chosen to generate a certain event upon fingerprint registration. If a user authenticates himself/herself with such a fingerprint, the authentication gets recorded in a log as duress fingerprint authentication. The system administrator can set a separate alarm using the log. | + | Note: Duress Finger is a special fingerprint chosen to trigger certain event upon the authentication by it. If a user authenticates himself/herself with a duress fingerprint, the authentication gets recorded in a log as duress fingerprint authentication. The system administrator can set a separate alarm using the log. |
{{:en:duressinput_2_.mp4?800x540}} | {{:en:duressinput_2_.mp4?800x540}} | ||
Line 14: | Line 14: | ||
- | 1) Go to User Menu and enroll two finger | + | 1) Go to User Menu and enroll two fingerprint templates |
2) Choose [Duress] option for one of the fingers and then, click [Enroll] button | 2) Choose [Duress] option for one of the fingers and then, click [Enroll] button | ||
Line 22: | Line 22: | ||
3) Click [Apply] of user information | 3) Click [Apply] of user information | ||
- | 4) Go to [Device] menu and click one of the connected device | + | 4) Go to [Device] menu and click one of the connected devices |
5) Click [Advance] | 5) Click [Advance] | ||
Line 44: | Line 44: | ||
{{:en:duress_05.png?600|}} | {{:en:duress_05.png?600|}} | ||
- | 9) Select the signal setting which is predefined and click [Apply] | + | 9) Select the predefined signal setting and click [Apply] |
{{:en:duress_06.png?800|}} | {{:en:duress_06.png?800|}} |