Differences
This shows you the differences between two versions of the page.
|
en:simultaneous_use_of_wiegand_in_out [2018/04/03 09:37] jypark created [Simultaneous use of Wiegand In & Out] |
en:simultaneous_use_of_wiegand_in_out [2021/12/17 10:32] (current) peterk |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ===== Simultaneous use of Wiegand In & Out ===== | ===== Simultaneous use of Wiegand In & Out ===== | ||
| ---- | ---- | ||
| - | Configuring Wiegand In & Out at the same time is required when special card reader which is not produced by Suprema is used under the environment where Suprema reader is connected with 3rd party controller. In this case, Wiegand Input signal is sent to Suprema reader when special card is scanned on the special card reader. Once Suprema reader receives the Wiegand Input signal from special reader, it requests you to authenticate your identity with means of additional authentication. \\ | + | Configuring Wiegand In & Out at the same time is required when a special card reader which is not produced by Suprema is used under the environment where the Suprema reader is connected to 3rd party controllers. In this case, the Wiegand Input signal is sent to the Suprema reader when this special card is scanned on the special card reader. Once the Suprema reader receives the Wiegand Input signal from the special reader, it requests you to authenticate your identity with a means of additional authentication. \\ |
| - | For example, if you use the authentication mode “Card + Fingerprint”, you should first scan the special card on the special card reader which is not produced by Suprema. After that, wiegand input signal is sent to the Suprema reader, you should scan your fingerprint on Suprema reader. Then, wiegand output signal is sent to 3rd party controller. | + | For example, if you use the authentication mode “Card + Fingerprint”, you should first scan the special card on the special card reader which is not produced by Suprema. After that, the Wiegand input signal is sent to the Suprema reader, you should scan your fingerprint on the Suprema reader. Then, the Wiegand output signal is sent to the 3rd party controller. |
| {{:en:biostar2_wiegand_input_output_1.png?nolink&1200|}} \\ \\ | {{:en:biostar2_wiegand_input_output_1.png?nolink&1200|}} \\ \\ | ||
| <callout type="info" icon="true"> | <callout type="info" icon="true"> | ||
| - | Supported Device | + | Supported Devices |
| - | * The Device which has two ports for wiegand. | + | * Devices with two ports for Wiegand. |
| * BioStation 2, BioStation A2, FaceStation 2 | * BioStation 2, BioStation A2, FaceStation 2 | ||
| </callout> \\ | </callout> \\ | ||
| Line 17: | Line 17: | ||
| 3. Select **Input/Output** option for **Wiegand**. \\ | 3. Select **Input/Output** option for **Wiegand**. \\ | ||
| - | {{:en:biostar2_wiegand_input_output_2.png?nolink&1000|}} \\ | + | {{:en:biostar2_wiegand_input_output_2.png?nolink&1000|}} \\ |