2019-09-25

1. OSDP Standardization

• Improved to comply with OSDP V2.1.7 protocol when connecting with 3rd-party controllers.

2. Increase of the number of administrators that can be added.

3. Support to the Clear APB for each user.
4. Supports options by card type.
5. Increase of the maximum number of floor levels to up to 2,048.
6. Add the event items to IMAGE LOG menu.
7. Change the way new settings are applied when adding administrators using batch edit of devices.

• Before: Overwrite a new setting to existing settings.
• After: Add a new setting to existing settings.

8. Supports the duplicate face check when registering users on a device.
9. Supports setting options for Wiegand authentication result output.

• User ID and Card ID

10. Supports Anti-Tailgating at doors.

11. If the data transmission fails when communicating with OSDP, it is transmitted again.

12. Improves the Enhanced fake face enrollment block.

13. Improves the usability.

• Expanded the area of the menu button.

14. Support for RS-485 connections to new devices

• XPass 2(XP2-MDPB, XP2-GDPB, XP2-GKDPB)

1. The master device abnormally shuts down if it is operated after reconnecting a disconnected slave device.
2. The master device reboots abnormally when a user authenticates the face to the slave device continuously.
3. The master device abnormally shuts down if the RS-485 mode of the master device is changed after disconnecting the 31 connected slave devices.

1.When upgrading firmware using USB, upgrade failed due to a timeout.

• Changed the timeout from 90 seconds to 5 minutes.

2. Scanning a deleted card to the device caused the device to restart abnormally.

3. The device recognized the iCLASS Seos card as a CSN card.

4. Importing user data exported from BioStation A2 caused the device to restart abnormally.

5. Start time was not applied in UTC when importing filtered logs using SDK.

6. Relay worked after reconnecting for authentication that occurred when elevator connection was disconnected.
7. Access was denied and user ID was displayed abnormally when using a smart card or fingerprint authentication in One Device Mode.
8. The Wiegand output data were transmitted in duplicate.
9. A delay occurred in opening the door when authentication succeeds, and the device UI was generally slow to respond.