How to configure CoreStation

Three new devices have been introduced with the release of BioStar 2.5:

CoreStation, Suprema’s first controller for a centralized access system; P2, the next generation model of BioEntry Plus; R2, the dummy reader designed to be used with CoreStation.

Since it is a centralized controller, CoreStation does not have a reading capability unlike other edge devices and its role is to control the slave and wiegand devices that are connected to the device.
It has 4 relays, 4 wiegand inputs, and 5 RS485 channels where you can connect slave devices.

The device’s input is supervised input. Which mean that the device can sense if the input has been tampered with just like the DM-20.
A log distinguishing a normal input or shorted input will be logged in the event log and a device action can be configured accordingly as well.
The device has a staggering matching 400,000 match per second.
This means you can have 8 devices sending biometric information at the same time and still have a match result in 1 second.
The device can store up to 500,000 users and 1 million fingerprints for 1:1 matching.
The benefit of having a centralized controller is that your dummy readers, which are on the door, do not store any user information.

Additionally if your site had RS485 wiring with no ethernet you can reuse the wiring as is.
By creating a daisy chain of 32 DM-20 with 4 Wiegand readers per device and 4 Wiegand readers on CoreStation’s interface you can control up to 132 doors with a single CoreStation.

It can control multiple DM-20s with a daisy chain and also control multiple biometric device and card readers at once. The slave devices will be connected with a RS-485 connection and the 3rd party RF readers will be connected with Wiegand wiring.
The CoreStation itself will have to be wired with an ethernet to connect to the BioStar 2 server.

CoreStation also comes with an optional enclosure which includes the power supply unit and the power distribution board.
You will have to purchase the battery locally at your country according to the specification guideline.
The battery will keep the CoreStation operational for around 30 minutes in idle status if the power goes out.
This time will differ based on the number of devices that are connected and how much the slave devices are used during this time.
The enclosure has a tamper switch that sends a tamper event every time the enclosure is opened. An event log will be created when the CoreStation loses power as well.

[R2 / P2]

The R2 and P2 devices are 2 additional devices that are introduced with BioStar 2.5. Both have the same exterior look. However the R2 devices only has a power and RS-485 connection because its purpose is to scan the card / fingerprint and send it to the master device.

CoreStation should be wired with Ethernet to connect to the server and the slave devices should be wired with RS485.

1. Log in to BioStar 2.

2. Click Device.

3. Click Search Device.

4. Select CoreStation and click Add.

5. Right click on CoreStation and click Search Slave Device.

6. Click Search and then Add your slave devices.

7. Click on CoreStation.

8. On Advanced configure your Tamper and AC Fail based on your wiring on the Aux Input to receive tamper and power failure logs.

9. If you’re using a supervised input, configure the resistor value as necessary on Supervised Input.

For a detailed wiring guideline, refer to the device manual and the guide on the enclosure.