Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
en:how_to_configure_d2_keypad [2019/02/26 22:36] yjjung [Adding as a Slave Device] |
en:how_to_configure_d2_keypad [2021/12/29 14:45] (current) peterk |
||
---|---|---|---|
Line 3: | Line 3: | ||
====== How to Configure D2 Keypad ====== | ====== How to Configure D2 Keypad ====== | ||
Xpass D2 Keypad is a new device introduced with BioStar 2.6.2. \\ | Xpass D2 Keypad is a new device introduced with BioStar 2.6.2. \\ | ||
- | It is a dummy reader for reading cards or PIN, which means it doesn’t perform data matching on the device. \\ | + | It is a dummy reader for reading cards or PIN, which means it doesn’t perform data matching on itself. \\ |
- | The device can be used as slave device, or a Wiegand reader to send Wiegand output. \\ | + | The device can be used as a slave device, or a Wiegand reader to send Wiegand output. \\ |
- | The device sends out a Wiegand signal with the default 26bit format and the Wiegand configuration will be done with a separate tool. \\ | + | The device sends out Wiegand signals with the default 26bit format and the Wiegand configuration will be done with a separate tool. \\ |
+ | - Link to the information about the tool: [[http://kb.supremainc.com/knowledge/doku.php?id=en:how_to_use_suprema_device_manager_app|How to use Suprema Device Manager App | ||
+ | ]] | ||
+ | \\ | ||
===== Adding as a Slave Device ===== | ===== Adding as a Slave Device ===== | ||
- | You will need a master device to add the slave D2 Keyapd device. \\ | + | You will need a master device to add the slave D2 Keypad device. \\ |
- | Refer to the article below to learn how to search a slave device. \\ | + | Refer to the article below to learn how to search for slave devices. \\ |
[[en:2xfaq_rs485_mode_master_default_slave]] | [[en:2xfaq_rs485_mode_master_default_slave]] | ||