Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
en:how_to_configure_xpass_d2 [2019/11/21 16:59] yjjung [How to Configure Xpass D2] |
en:how_to_configure_xpass_d2 [2021/12/17 10:26] (current) peterk |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | {{tag>"System Configuration" "BioStar 2" "Xpass D2"}} | + | {{tag>"System Configuration" "BioStar 2" "XPass D2"}} |
- | ====== How to Configure Xpass D2 ====== | + | ====== How to Configure XPass D2 ====== |
- | Xpass D2 is a new device introduced with BioStar 2.6. \\ | + | XPass D2 is a new device introduced with BioStar 2.6. \\ |
- | It is a dummy reader for reading cards, which means it doesn’t perform data matching on the device. \\ | + | It is a dummy reader for reading cards, which means it doesn’t perform data matching on itself. \\ |
- | The device can be used as slave device, or a Wiegand reader to send Wiegand output. \\ | + | The device can be used as a slave device, or a Wiegand reader to send Wiegand output. \\ |
- | The device sends out a Wiegand signal with the default 26bit format and the Wiegand configuration will be done with a separate tool. | + | The device sends out a Wiegand signal with the default 26bit format and the Wiegand configuration will be done with a separate tool Device manager. \\ |
- | Please refer to the article : [[en:how_to_use_suprema_device_manager_app|How to use Suprema Device Manager App]] \\ | + | Please refer to the article: [[en:how_to_use_suprema_device_manager_app|How to use Suprema Device Manager App]] \\ |
===== Adding as a Slave Device ===== | ===== Adding as a Slave Device ===== | ||
You will need a master device to add the slave D2 device. \\ | You will need a master device to add the slave D2 device. \\ | ||
- | Refer to the article below to learn how to search a slave device. \\ | + | Refer to the article below to learn how to search for a slave device. \\ |
[[en:2xfaq_rs485_mode_master_default_slave]] | [[en:2xfaq_rs485_mode_master_default_slave]] | ||
Line 15: | Line 15: | ||
===== Using the device as a Wiegand Reader ===== | ===== Using the device as a Wiegand Reader ===== | ||
- | If you have already used the device as a slave device before, you must reset the device to use it as a Wiegand reader (sending Wiegand output). \\ | + | If you already have used the device as a slave device before, you must reset the device to use it as a Wiegand reader (sending Wiegand output). \\ |
- | 1. Delete the device from BioStar 2 client as a slave device. \\ | + | 1. Delete the device(slave device) from BioStar 2 client. \\ |
{{:en:2x_sc_xpass_d2_02.png?nolink&250|}} \\ | {{:en:2x_sc_xpass_d2_02.png?nolink&250|}} \\ |