문서의 이전 판입니다!

Version 1.5.0 (V1.5.0_220621)

Release

2022-06-21

신규 BLE 칩 및 SE 프로세서가 적용된 장치의 경우 펌웨어를 v1.5.0으로 업그레이드 한 뒤 하위 버전으로 다운그레이드 할 수 없습니다.
기존 BLE 칩 및 SE 프로세서가 적용된 장치는 하위 버전으로 다운그레이드 할 수 있습니다.
장치의 신규 BLE 칩 및 SE 프로세서 적용 여부는 장치의 시리얼 번호를 확인한 뒤 슈프리마 홈페이지(supremainc.com)에 문의하십시오.

New Features and Improvements

1. Added new models that do not support BLE (Bluetooth Low Energy).

  • BLN2-OA, BLN2-OD

2. Supports setting the byte order for smart cards.

  • Supports setting the byte order of data to be output to Wiegand or OSDP.

3. Supports a new BLE (Bluetooth Low Energy) chip.

  • The BLE chip parts of the hardware have been changed, and the firmware has been upgraded to be compatible with both the existing and new BLE chips.

4. Supports the dual SE processor.
5. Separated the log related to door unlock.

  • Door Unlocked (Exit Button)
  • Door Unlocked (By Operator)

6. Added relay deactivation option for exit button input.

  • Added the option to set the door open request log to occur but the relay not to operate when the exit button is pressed.

7. Supports Live Finger Detection.

Bug Fixes

1. Mobile card authentication suddenly does not work (Affects version: v1.3.2).
2. Global APB behavior for the same input was different depending on firmware version (Affects version: v1.4.0).
3. Device does not connect to a 3rd party controller (Software House iSTAR Edge G2) via OSDP (Affects version: v1.4.1).
4. When changing the intelligent slave settings on the detailed page of the device on BioStar 2, the settings were not applied (Affects version: v1.4.2).
5. Migration malfunction occurs when the firmware is upgraded from v1.2.0 or earlier to v1.3.0 or later (Affects version: v1.3.0).

  • Migration did not complete and the device boots to the main screen, some keys do not work or an abnormal screen is displayed.

6. When the device was communicating with a 3rd party system via OSDP, if the Input Status Request command was sent after the input port was grounded, the output was ’Inactive’ (Affects version: v1.4.1).
7. If sending the Output Status Report Request command when the device was communicating with a 3rd party system via OSDP, the relay works, but the Output Status Report does not output (Affects version: v1.4.1).
8. When the device was communicating with a 3rd party system via OSDP, if the Output Status Request command was sent while relay status was ON, the output was ’Inactive’ (Affects version: v1.4.1).
9. Device does not recognize some HID iCLASS Seos cards (Affects version: v1.0.0).